The force sensor design allows unbelievable assembling solutions. Thanks to the huge inner hole the sensor can be installed i which applications where is necessary crossing shaft, pin, chips or scrap flash trough the force sensor hole.
the force sensor assembling will be very easily, through the two rings of holes on the edges is possible execute tensile and compressive force measurement directly on the force sensor shell without any adaptor.
Thanks to the inner and outer diameters machined in tolerance quality IT7, The force sensor SF provide a lot of advantages versus the standard force sensor with the threaded inner hole. The inner diameter machined in tolerance allow the centring of components or tools, thus our sensor is very versatile and can be use used in several applications, because in this way the inner hole won't be used only for the scope of a free passage for shaft or others. The tight tolerance allow a precise alignment of the component assembled on it and the bolts tightening don't make any preload problems. The holes to fixing the sensor can be available as threaded holes of through holes.